ZMODO CM-Z2212GY Manuel d'utilisateur Page 31

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 43
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 30
User Manual
28
Cruise Set
Open auto cruise function on PTZ setting menu if you want to setup cruise function (system default: off),
and set up cruise channel, cur point and total quantity and stop time etc.
Picture 5-41
Channel select: select the channel with the PTZ camera
Total: set up presetting bit quantity
Cur Point: System has default starting (current) cruise point as 01. You can use this option to set additional
cruise points.
Stop time: sets the pause time at each stop.
GOTO: select this option to go to specific preset points.
Set: save the preset point. After setting channel and setting the position by adjusting PTZ direction key you
click [Set] button to setup the pre-set point. Please note you will click the [Save] button to finish the setting
successfully. If you want to combine Zoom, Iris, Focus and direction keys into the pre-set setting, please
return to previous menu (shown as Picture 5-41) to add additional settings, and then enter into Cruise Set
again and click [Set] and [Save] to make sure your setting is setup successfully.
Clean: remove settings.
Note: this DVR model supports up to 100 pre-set points. But actual quantities may be restricted by the PTZ
camera you are using.
5.6 PIP mode
PIP display is one kind of Live display, including 1x1 display mode and 1x2 display mode.
1x1 display mode: There are one full screen video image on the screen, one another small screen image
shown on the above
1x2 display mode: There are one full screen video image on the bottom of screen, another two small screen
images shown on the above.
5.7 Recording search
Click pop-up menu to enter into [Recording Search] menu quickly, now you could proceed recording search and
playback. Details please refer to section 5.2.4.
5.8 Mute
The option allows you control volume of DVR
5.9 Record
Click [Rec.] button to start manual recording.
Vue de la page 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 42 43

Commentaires sur ces manuels

Pas de commentaire